How to install front license plate bracket on chevy equinox

HOW TO INSTALL FRONT LICENSE PLATE BRACKET ON CHEVY EQUINOX SERIES

With the spindle disconnected the U-bolts holding the lower control arms to the crossmember are removed.While the alignment will need to be checked when the installation is complete, replacing the original shims should be close to correct. Hamusek kept track of the alignment shims in the upper control arms.With the spring removed the spindle can be separated from the lower control arm.To remove each coil spring the lower control arm is supported by a floorjack, the upper ball joint is separated from the spindle, then the lower control arm is slowly lowered to allow removal of the coil spring.Note the brackets for the shock (arrows) that was removed earlier. The disc brake calipers were removed and hung from the frame with mechanics wire.This is a good time to replace them if any wear is evident. Next the tie-rod ends are removed from the steering arms.Aaron Hamusek began disassembly of the front suspension by removing the sway bar endlinks.TheyвЂ™re designed to add caster to increase straight line stability. POLвЂ™s upper control arms come with new ball joints, bumpstops, and cross shafts.This flat plate is a guide used for cutting holes in the upper spring pockets that the coilovers will pass through.Included in the POL kit are these bolt-on upper coilover mounts.Note the damping adjustment knobs at the top of the shocks. For small-block applications, 450-pound springs are recommended big-blocks use 550 pound.

HOW TO INSTALL FRONT LICENSE PLATE BRACKET ON CHEVY EQUINOX SERIES

At the center of the conversion are the Aldan Phantom series coilovers.Previously it was equipped with lowered coil spring control arms and a disc brake conversion. The subject of Orange County Hot RodsвЂ™ coilover suspension installation was POLвЂ™s workhorse C10.This kit will give huge performance increases, ready for the street or track. WeвЂ™re over at Orange County Hot Rods showing you a step by step installation of POLвЂ™s Chevy C10 Coilover Conversion Kit.

How to install front license plate bracket on chevy equinox